The fin stamping machine needs a lot of safe operation rules when we use it

Fin stamping machine in our use of a lot of safety operation specifications, today's fin punch processing manufacturers to give you a detailed introduction.

1、 The operator must be familiar with the structure and performance of the machine tool. It is not allowed to operate the equipment without the approval or designated personnel. A kind of

2、 Before operation, it is necessary to check whether the oil quantity and lubrication point of centralized lubrication station are sufficient, and add oil according to regulations.

3、 Before starting the machine, the mould must be maintained and checked to ensure that the mould is installed correctly, without abnormality, safe and reliable. A kind of

4、 Before stamping, the protector and pressure gauge should be checked, and the slow stamping test machine can be carried out after confirming that everything is normal.

5、 During operation, the number of trips should be controlled between 60 and 150 times / min. it is strictly forbidden to run over the speed limit, or to increase or decrease the speed suddenly, so as to avoid frequent inching operation.

6、 If it is necessary to maintain, debug or repair the machine tool and mold, it must be carried out under the condition of pressing the emergency stop button and confirming the safety. A kind of

7、 During operation, no hard objects are allowed to enter the stamping range of the die; tools and other floating objects are not allowed to be placed on the mold surface or material surface.

8、 When stopping the machine, it is strictly forbidden to keep the slide block or die at the bottom dead center to prevent the mold from being stuck. The sliding block should be lifted to the upper dead center.

9、 Pay attention to the forced air blowing chip removal device during operation. When the device fails or the air pressure is insufficient, it is forbidden to operate. A kind of

10、 Pay attention to the operation of the equipment and mould during the working process. Stop the machine when the work is finished or leave temporarily. In case of any abnormality or failure, stop the machine in time for maintenance or report to the competent department for handling.

11、 Cut off the power supply and air source after work; clean the site, wipe the machine tool and keep it clean.